Arpeggiator
Press the [SUSTAIN] and [HARMONY] buttons at the same time to turn
on the arpeggiator. The “ARP.” indicator lights up on LCD. Repeat this
operation to turn off the arpeggiator.
Arpeggiator split point
When the arpeggiator is in use, the keyboard will be split into two
sections. Play chords in the left hand section, and play melody in the
right hand section. The default split point is F#3 (19) (same as the split
point in Split mode). You can change the split point in the function
menu.
Harmony
Press the [HARMONY] button to turn this function on or off.
When harmony is in use, the “HARMONY” indicator will light up on
LCD. Turn on the Fingered function, then play a chord in the chord
section. When you play in the right hand section, it will add harmony
effect to the notes.
Setting the harmony type
Press the [FUNCTION] button to enter the function menu. Use the data
dial to select “HrmXXXX”, then use the [<] / [>] buttons to change the
harmony type. Pressing [<] and [>] buttons at the same time will reset
to the default setting.
Notes:
Harmony types “1+5” and “octave” are always available, but the rest
will not work until you turn on the Fingered function and then play a
chord in the chord section.
Performance Enhancement
12
To Next Page
Loading...
Need help?
General
