39
EN
FREQUENCY
(only in DVB-C
mode)
Set the frequency. The default setting is
AUTO.
Only active if the NETWORK SCAN op-
tion has been selected in the Search
mode settings.
SYMBOL
RATE
(only in DVB-C
mode)
Set the symbol rate.
SORTING BY
LCN
Logical Channel Numbering: Select the
ON setting if you want to sort the chan-
nels based on a preset channel list (if
available from the channel supplier)
After you have configured all the settings, press OK. The
channel search will then start.
If you have selected the source SATELLITE, the following
setting options are available:
COUNTRY Select the desired country for the chan-
nel search.
SATELLITE Select the satellite on which the search
will be started.
SCAN MODE
Set the search mode.
DEFAULT: A search will be carried out
on the selected satellite, based on the
transponder list saved for this satellite.
This requires a little time.
NETWORK: Activate/deactivate the
network scan.
BLIND SCAN: A complete search will
be carried out on the selected satel-
lite. This will also take into account new
transponders that have not been added
to the list of transponders. Two searches
are carried out with the blind scan. The
first search identifies the transponders
for the satellite, while the second search
locates the channels. The blind scan
takes the longest time.
To Next Page
Loading...
