65
EN
13.5. SETUP menu in DVD mode
Press the D.SETUP button in DVD mode. The main page of the SETUP menu ap-
pears on the screen.
13.5.1. Navigating in the menus
Use to select between the menus. The active menu is highlighted in or-
ange. Use to select the menu options; the selection options will be shown
on the right-hand side. The active setting is highlighted in brown.
To change a setting, use to go to the right-hand side and then select a differ-
ent option using . Press OK to confirm.
Use to get to the higher-level menu selection.
Press D.SETUP to leave the setup menu at any point.
13.5.2. General Setup Page
TV SYSTEM
Select the colour standard of your television here:
− PAL: Usual colour format for many European countries.
− AUTO: Automatic format setting.
− NTSC: Usual colour format for North America.
TV TYPE
Here you set the device‘s display format to match that of the television.
− 4:3 PS: Selection for televisions with a 4:3 format. The pan scan format dis-
plays 16:9 film formats in full height; the side sections of the image are cut
off.
− 4:3 LB: Selection for televisions with a 4:3 format. The letterbox format re-
duces the 16:9 film format to the size of the screen.
− 16:9: Selection for televisions with 16:9 format.
OSD LANGUAGE
This sets the OSD (on-screen display) language, i.e. the language for the device
menus.
Once you select a language the menu changes immediately.
SCREEN SAVER
If the screen saver is activated, a screen saver will appear if no buttons are pressed
for 3 minutes (but not during playback).
RESUME
With this function, the DVD player remembers where the last DVD was at when it
was stopped. If you insert the same DVD into the device again, playback will resume
from the last position. The last position on the DVD will be remembered even if the
device is switched off.
To Next Page
Loading...
