MegaPoints Controllers Servo Controller - Specifications

MegaPoints servo controller Revision 24 April 2016
www.loolee.org Page: 14
Specifications
The MegaPoints Servo Controller was lovingly designed and crafted in the United Kingdom by
railway enthusiasts, for railway enthusiasts.
Channels
12 servo / points outputs, each with the following independent settings:
 High and low end point adjustment
 Rotation speed (1 – 3)
 Reverse
Memories
3 (M1 – M3)
Power supply
9 – 14 volts smoothed DC (reverse polarity protected) .
Current
Less than 200 mA + servo load. 2 amps peak with built in voltage regulator.
Expansion
Yes, via 2 x network connectors (on lower right of board).