15 / 42 9742146
7.2 Preparing for cleaning
The preparatory work described below must be carried out before each commissioning.
• Insert the sieve.
Caution! Danger of crushing!
Close the door with both hands!
• Switch on the appliance by pressing one of the programme preselection buttons.
During the filling and heating phase, the light above the preselection button will flash.
When the light remains constantly lit, the appliance is ready for operation.
The time required to reach operation readiness depends on the supply water
temperature and the installed boiler or tank heating capacity.
If using a cold water connection, this process takes approx. 18 minutes.
7.3 Automatic dosing
The required disinfectant and cleaning agent, as well as the rinse aid, is fed from the
storage tanks into the tank or boiler by electronically-controlled dosing equipment. Dosing
occurs automatically based on the requirements of the cleaning process.
Use of unsuitable products will significantly impact the service life of the dosing
equipment.
7.4 Operation during cleaning
The following fundamental principles must be observed when placing the face masks in
the baskets:
• Special baskets are provided for the masks.
• Place the masks and the small items in the intended positions in the baskets.
7.4.1 Start the programme
button
• Place the basket in the appliance, ensuring that it is correctly centred in the basket
holder.
• Close the door.
• Press the programme start button.
The appliance cleans and disinfects automatically and switches off the wash programme
after completion. The programme sequence is shown by the indicator at the programme
start button.
The cleaning time can differ from the set programme running time if the boiler heating
capacity or tank heating capacity is not sufficient to heat up the fresh water flowing into
the boiler or the tank water to the required temperature during the programme time.
7.4.2 Remove the basket
• When the light goes out, open the door and remove the basket.
To Next Page
Loading...
