9742146 20 / 42
10.1.7 Rinse aid dosing
The rinse aid dosing unit is designed to automatically add liquid and clean final rinse aid
into the fresh water.
The rinse aid is pumped out of the storage tank into the fresh water supply line through a
hose conduit. The dosing equipment is self-priming. Dosing takes place during each filling
cycle.
We recommend rinse aid dosing of 0.2 ml/l.
The correct dosage leads to an even water film.
In case of overdosing, bubbles and stripes will form, which means that the dosage
needs to be reduced.
In case of under-dosing, water drops remain on the washed items - increase dosing.
10.2 Noise emission
Work place noise level LpA ≤ 70 dB
10.3 Data on electrical and hydraulic equipment
See the attached dimensional drawing
10.4 Dimensions, technical data, installation instructions
See the enclosed documentation
10.5 EC-/EU-Declaration of Conformity
See separate EC-/EU-Declaration of Conformity
11 Non-ionising radiation
Non-ionising radiation is not produced intentionally but unfortunately comes about due to
electrical operating equipment (e.g. electrical motors, high-voltage cables and magnetic
coils).
In addition, the machine has no strong permanent magnet. There is a high possibility of
eliminating any influence on active implants (e.g. pacemakers, defibrillators) by
maintaining a safety distance of 30 cm (distance of the field source to the implant).
To Next Page
Loading...
