To Next PageTo Next PageHow to reset factory setting parameter list on Meiko TopClean Washer?
To reset the parameters of your Meiko Washer to factory settings if the factory setting parameter list is active, switch the power supply on and off within five minutes. Note that after this reset, further attempts will be rejected, and parameters will be retained.
What to do if Meiko Washer says door not closed?
To fix the 'Door not closed' error on your Meiko Washer, check the S1 connection, change the microswitch, check the microswitch adjustment or replace the defective I/O circuit board.
Why does my Meiko Washer say maintenance required?
Maintenance is required because the set operating hours (P122) or batch number (P123) has been reached. Inform the service department and perform maintenance. Additionally, you may need to reset the maintenance counter (P124).
Why is the emergency programme active on my Meiko TopClean Washer?
If the emergency program is active on your Meiko Washer, and washing is restricted, it could be due to no boiler or tank heating, or no fresh water supply. Check the system to resolve these issues.
What to do if Meiko Washer says incorrect password?
If your Meiko Washer displays 'Incorrect password/no authorization', enter the code once again.
General| Capacity | 7 kg |
|---|---|
| Spin Speed | 1400 rpm |
| Noise Level (Washing) | 49 dB |
| Noise Level (Spinning) | 74 dB |
| Water Consumption | 45 liters per cycle |
| Dimensions (H x W x D) | 85 x 60 x 60 cm |
| Weight | 68 kg |
| Color | White |
Operator's responsibilities for ensuring safe operation, including planned measures and checks.
Specific safety instructions for personnel working on the appliance's electrical components.
Procedure for safely disconnecting the appliance from the power supply in an emergency.
Essential checks and procedures for safe and correct initial commissioning by qualified personnel.
Guide to identifying and resolving common malfunctions such as filling issues, spray problems, and foam formation.
Accessing service parameters, viewing/modifying parameters, and hose ventilation procedures.
Guide to interpreting information displays and identifying possible causes of operational issues.
Detailed list of error messages and their potential causes and solutions.
Mandatory safety precautions to be followed before, during, and after maintenance work.
