Refer to www.meir.com.au for tolerances, flow rates and other additional information | 3332
INSTALLATION INSTRUCTIONS (CONTINUED) FREESTANDING BATH SPOUT
3. Measure from the surface of the back plate and cut the lock nut and the
spindle to the same lengths.
4. Screw the handle connector in place, then fasten the handle. Orientate
the handle correctly to show the ‘H’ and ‘C’ in the bottom position when
the cartridge is closed.
1. Aerator
2. Spout
3. Screw
4. O-ring
5. Back plate
6. O-ring
7. Base plate
1
2
3
4
5
6
7
To Next Page
Loading...