| 3130
ROUND WALL TAPS
1 2 3 4 5 6 7 8 9 10
11 2 3
1. Cartridge (Hot)
2. Fiber Washer
3. Lock Nut
4. O-ring
5. Base plate
6. Connector
7. Screw
8. Handle
9. Button
10. Screw
11. Cartridge (Cold)
INSTALLATION INSTRUCTIONS
1. Before installation please take note of the installation tolerances,
as well as the turning directions of the H and C cartridges.
CLOSED CARTRIDGE
MAX HOLE DIAMETER = 40MM
OPEN CARTRIDGE
OPENING DIRECTION
TOLERANCE
2. Separate the lock nut from the cartridge. Install the cartridge tightly into
the breech in the wall, then fasten the lock nut tightly over the cartridge.
Screw the base plate over the lock nut, against the wall surface finish.
To Next Page
Loading...