Refer to www.meir.com.au for tolerances, flow rates and other additional information | 54
PRECAUTIONS FOR INSTALLATION
• Installation must only be completed by a licensed plumber
or tradesperson.
• When installing products, all pipes must be flushed clean
before installation.
• The water pressure must be tested. Where the water pressure exceeds
500Kpa, an approved pressure reducing valve should be fitted.
• Always fit isolating taps to the hot and cold inlet connections in
accordance with the Australian national plumbing code AS3500.
• Ensure the hoses are not twisted or stretched, are not under tension
and not bent to a radius less than 25mm when being installed.
• If the water temperature exceeds 75°C, an approved water tempering
valve must be fitted.
• For domestic use only.
• The plumber or tradesperson must generate a certificate or ocial
statement showing the work and tests completed. This certificate
or receipt must be kept and provided to Meir during any warranty
claim request.
• Follow the ‘Care and Cleaning’ guide on:
meir.com.au/pages/warranty
• Failure to comply with all the above instructions will void all warranties.
THE WARRANTY WILL BE VOIDED DUE TO:
• Normal and fair wear and tear, misuse, abuse, or mishap.
• The exposure to excessive moisture derived from lack of ventilation.
• The inability to provide proof of purchase.
• Products not installed by a licensed tradesperson, failure to
follow installation instructions or damage which arises from or
during installation.
• Scratches or damage caused by applying physical and or abrasive
contact directly to the product.
• The product being damaged by accident or neglect.
• Incorrect use of the product in accordance with any applicable
Instruction Guides.
• The purchaser attempting to modify or repair the product.
• Full Warranty and Terms & Conditions can be viewed at:
meir.com.au/meir-australia-warranty/
WARRANTY
To Next Page
Loading...