MELICONI Universal 2 - Noting the Programmed Code; Using the Additional Commands Which Do Not Appear on the Keypad; Using the Remote Control for 2 Tvs; Volume Control Available at All Times

+
NOTING THE PROGRAMMED CODE
To find the code for your remote control:
1.Press one of the TV or VCR selection
buttons for the appliance whose code
you want to identify.
2. Hold down the SHIFT and ON/OFF
buttons together until the TV or VCR
selection buttons start to flash.
3. Release the SHIFT and ON/OFF
buttons and then press and release
the 1-/-- button.
4. After a few seconds, the TV or VCR
selection button you used
communicates the code by flashing
the three numbers separately.
Count the number of flashes for each
code number. For example, for the
code 306, the button flashes three,
zero and six times to give:
= 3
= 0
= 6
5. Note this code on the label inside the
battery cover, for rapid consultation.
USING THE ADDITIONAL COMMANDS WHICH DO NOT APPEAR ON THE KEYPAD
Although not indicated on the keypad, some buttons can be used for additional commands.
1. Use your Universal 2 remote control to find them by pressing the following buttons one by
one or together with the SHIFT button:
2. The most frequently used additional commands like MENU SCROLL – COLOUR –
BRIGHTNESS and NORMALISATION are located as follows:
normalisation
menu (up) menu (up) + brightness (-) red brightness (-) + red
menu (down) menu (down) + brightness (+) green brightness (+) + green
menu (right) menu (right) + color (-) yellow color (-) + yellow
menu (left) menu (left) + color (+) blue color (+) + blue
USING THE REMOTE CONTROL FOR 2 TVs
You can use the remote control for 2 TVs instead of 1 TV and 1 VCR.
VOLUME CONTROL AVAILABLE AT ALL TIMES
You can raise or lower the TV volume or use the mute function while
watching the VCR without having to press the TV selection button.
1-/-- 2- MENU OK AV
-
P
+
P
-
+
-
P
+
P
-
+
-
SHIFT
SHIFT
SHIFT
SHIFT
SHIFT
SHIFT
SHIFT
SHIFT
OK
SHIFT
VCR
TV
1-/--
Always write down the 3-digit code for your remote control on the label inside the
battery cover after running the search and saving the code. This may be useful if you
need to reprogram your remote control in the event of accidental cancellation or when
you change used batteries.
If you forget to write down the code or use the remote control programming
procedures A or C …. don’t worry!
4. Enter the two codes following
programming procedure B
from point 3.
Start by pressing the TV
selection button to enter the code
for the first TV and then the VCR
selection button to enter the
code for the 2
nd
TV.
1. Look for the code for the first TV,
following any of the programming
procedures A , B or C described
above.
2. Make a note of the three-figure code
identified.
3. Repeat the search for the second TV
and make a note of the code.