70
11.4 Integrated descaling programme
The integrated descaling programme removes limescale in the interior of the
appliance. It requires a total of approximately 25 minutes. The symbol for descaling
ashes during the entire process.
Prerequisite: The appliance must be switched off (see „Switching on and off“
on page 52).
Caution!
– Carry out the integrated descaling programme every 3 months or when the
descaling symbol illuminates on the display.
– Only use Melitta
®
ANTI CALC Espresso Machines descaling agent.
These descaling products are exactly designed for the Melitta
®
CAFFEO
®
LATTEA
®
.
– Never use vinegar or other descaling agents.
Run the integrated descaling programme as follows:
1 Before descaling, remove – if in use – the Melitta
®
Claris
®
water lter
from the water tank.
2 Remove the milk canister.
3 Simultaneously press both the button for two-cup dispensing and
the ON/OFF button for about 3 seconds.
→ The symbol for descaling is ashing.
The symbol for the drip tray is illuminated.
Phase 1
During Phase 1, one bean symbol is shown on the display.
4 Empty the drip tray and coffee grounds container.
5 Reinsert the drip tray without the coffee grounds container and place
the coffee grounds container under the milk shower.
→ The symbol for the water tank illuminates.
6 Open up the ap of the water tank (Fig. A, no. 7) and pull the water tank
up and out of the appliance and then empty it completely.
Heft_Lattea_EU_2_3.indd 70 09.04.2014 14:04:23
To Next Page
Loading...
