Rev 1.8
Mellanox Technologies
12
Installing the Switch in the Rack
Tools and Customer Supplied Parts
Figure 1: Rack Rail Kit Parts MIS00083/85
Make sure that the Rail kit is compatible with your rack.
For short depth switches, rail kit # MIS00083 is to be used for racks from 50cm to 80cm deep,
and rail kit # MIS00079 is to be used for racks from 38cm to 50cm deep including the iDataPlex
rack.
For standard depth switches rail kit # MIS00085 is to be used for racks from 60cm to 80cm deep.
Parts included in the rail kit:
• Phillips Screwdrivers #1 and #2 • Grounding screw
• ESD strap • Grounding wire sufficient to reach a valid ground.
•ESD mat
• 2 rails • 18 recessed flat head screws
• 2 rail slides • 8 caged nuts
• 2 brackets • 8 pan head screws M6
To Next Page
Loading...
Need help?
General
