Rev 1.8
Mellanox Technologies
31
Starting a WebUI Connection to the Switch
1. Set up an Ethernet connection between the switch and a local network machine (“the remote
machine” henceforth) using a standard RJ-45 connector.
2. Start a Web browse – Internet Explorer 7.0 or Mozilla Firefox 3.0.
Note: Make sure the screen resolution is set to 1024*768 or higher.
1. Enter as URL the following: http://<switch_IP_address>
where <switch_IP_address> is the IP address of the switch or its DNS name.
2. You will receive the login window for remote management of the switch.
3. Use admin for both the login (Account) and the password.
To Next Page
Loading...
