Mellanox Technologies MIS5025 - Table 9: Configuration Wizard Session

To Next Page

To Previous Page

Rev 1.8

Mellanox Technologies

4. Before attempting a remote (for example, SSH) connection to the switch, check the eth0

interface configuration. Specifically, verify the existence of an IP address. To check the cur

rent eth0 configuration, enter the following commands:

switch-112428> enable // Enter ‘enable’ mode of CLI

Table 9 - Configuration Wizard Session - Static IP Configuration

Wizard Session Display - Static IP Configuration (Example)

Mellanox configuration wizard

Do you want to use the wizard for initial configuration? y

Step 1: Hostname? [switch-112126]

Step 2: Use DHCP on mgmt0 interface? [yes] n

Step 3: Use zeroconf on mgmt0 interface? [no]

Step 4: Primary IP address? 192.168.10.4

Mask length may not be zero if address is not zero (interface eth0)

Step 5: Netmask? [0.0.0.0] 255.255.255.0

Step 6: Default gateway? 192.168.10.1

Step 7: Primary DNS server?

Step 8: Domain name?

Step 9: Enable IPv6? [yes] yes

Step 10: Enable IPv6 autoconfig (SLAAC) on mgmt0 interface? [no] no

Step 11: Admin password (Enter to leave unchanged)?

You have entered the following information:

1. Hostname: switch-112126

2. Use DHCP on mgmt0 interface: no

3. Use zeroconf on mgmt0 interface: no

4. Primary IP address: 192.168.10.4

5. Netmask: 255.255.255.0

6. Default gateway: 192.168.10.1

7. Primary DNS server:

8. Domain name:

9. Enable IPv6: yes

10. Enable IPv6 autoconfig (SLAAC) on mgmt0 interface: no

11. Admin password (Enter to leave unchanged): (unchanged)

To change an answer, enter the step number to return to.

Otherwise hit <enter> to save changes and exit.

Choice:

Configuration changes saved.

To return to the wizard from the CLI, enter the "configuration jump-start"

command from configure mode. Launching CLI...

switch-1 >

Mellanox Technologies MIS5025 - Table 9: Configuration Wizard Session - Static IP Configuration