Mellanox Technologies MIS5025 - Table 8: Configuration Wizard Session

To Next Page

To Previous Page

Rev 1.8

Mellanox Technologies

Table 8 - Configuration Wizard Session - IP Zeroconf Configuration

Wizard Session Display - IP Zeroconf Configuration (Example)

Mellanox configuration wizard

Do you want to use the wizard for initial configuration? y

Step 1: Hostname? [switch-112126]

Step 2: Use DHCP on mgmt0 interface? [yes] no

Step 3: Use zeroconf on mgmt0 interface? [no] yes

Step 4: Default gateway? [For example:192.168.10.1]

Step 5: Primary DNS server?

Step 6: Domain name?

Step 7: Enable IPv6? [yes] yes

Step 8: Enable IPv6 autoconfig (SLAAC) on mgmt0 interface? [no] no

Step 9: Admin password (Enter to leave unchanged)?

Step 9: Confirm admin password?(Enter to leave unchanged)?

You have entered the following information:

1. Hostname: switch-112126

2. Use DHCP on mgmt0 interface: no

3. Use zeroconf on mgmt0 interface? [no] yes

4. Default gateway: 192.168.10.1)

5. Primary DNS server:

6. Domain name:

7. Enable IPv6: yes

8. Enable IPv6 autoconfig (SLAAC) on mgmt0 interface: no

9. Admin password (Enter to leave unchanged): (unchanged)

To change an answer, enter the step number to return to.

Otherwise hit <enter> to save changes and exit.

Choice:

Configuration changes saved.

To return to the wizard from the CLI, enter the "configuration jump-start"

command from configure mode. Launching CLI...

switch-1 >

Mellanox Technologies MIS5025 - Table 8: Configuration Wizard Session - IP Zeroconf Configuration