Rev 1.8
Mellanox Technologies
22
Step 5: Admin password (Press <Enter> to leave
unchanged)? <new_password>
Step 6: Confirm admin password?
<new_password>
To avoid illegal access to the machine, please
type a password and then press <Enter>. Then
confirm the password by re-entering it.
Note that password characters are not printed.
You have entered the following information:
1. Hostname: <switch name>
2. Use DHCP on mgmt0 interface: yes
3. Enable IPv6: yes
4. Enable IPv6 autoconfig (SLAAC) on mgmt0
interface: no
5. Admin password (Enter to leave unchanged):
(CHANGED)
To change an answer, enter the step number to
return to.
Otherwise hit <enter> to save changes and exit.
Choice: <Enter>
Configuration changes saved.
To return to the wizard from the CLI, enter the
“configuration jump-start” command from con
-
figuration mode. Launching CLI...
<switch name> [>
The wizard displays a summary of your choices
and then asks you to confirm the choices or to re-
edit them.
Either press <Enter> to save changes and exit, or
enter the configuration step number that you wish
to return to.
Note:
To run the command “configuration jump-start”
you must be in Config mode.
Table 7 - Configuration Wizard Session - IP Configuration by DHCP (Sheet 2 of 2)
Wizard Session Display (Example) Comments
To Next Page
Loading...
