Installation
Rev 1.6
Mellanox Technologies
20
Figure 11: Attaching the Brackets to the Chassis
Step 4. Install 8 cage nuts in the desired 1U slots of the rack: 4 cage nuts in the non-extractable side (in
the top and bottom holes only) and 4 cage nuts in the extractable side.
Figure 12: Installing the Cage Nuts
While your installation partner is supporting the system’s weight, perform the following steps:
Step 5. Mount the system into the rack enclosure, and attach the brackets installed on the system to the
rack’s posts. Secure the brackets to the rack’s posts by inserting four M6 screws in the desig
-
nated cage nuts, as described in Figure 13. Do not tighten the screws yet.
While each rack U (unit) consists of three holes, the cage nut should be installed verti-
cally with its ears engaging the top and bottom holes only.
To Next Page
Loading...
