Mellanox Technologies SN2100 - Side by Side Mounting for SN2100 Rail Kit

Installation Rev 1.6
Mellanox Technologies
31
2.5.4 Side by Side Mounting for SN2100 Rail Kit
The following parts are included in the rail kit (see Figure 30):
• 1 metal frame for two systems (A)
• 2 system mounting blades with 8 screw holes - the kit contains enough rails to install 2
systems (B)
• 2 system mounting blades with 7 screw holes - the kit contains enough rails to install 2
systems (C)
• 2 frame rail slides (D)
• 30 flat head 4-40 screws - the kit contains enough screws to install 2 systems (E)
• 2 blank covers (F)
• 10 (+2 spare units) M6 pan head screws (G)
• 10 (+2 spare units) M6 spring washers (H)
• 10 (+2 spare units) M6 spring steel cage nuts (I)
• 6 (+2 spare units) cable-ties (J)
A designated rail kit for the SN2100 systems can be purchased separately.
This section is relevant to short-depth systems that allow such form of installation
only.
At least two people are required to safely mount the system in the rack.
Table 10 - Installation Kit
Kit OPN Rack Size and Rack Depth Range
MTEF-KIT-D Rack installation kit for SN2100 series short depth 1U switches, allows instal-
lation of one or two switches side-by-side into standard depth racks