Installation
Rev 1.6
Mellanox Technologies
34
Step 4. While holding the cables stably together in the blade’s rail with one hand, use your other hand
to secure the blades to the chassis. Screw the right blade with eight 4-40 flathead screws, and
the left blade with seven 4-40 flathead screws. The recommended torque is 0.49-0.54 Nm.
Figure 34: Attach the Blades to the System
Figure 35: Attached Rail with Threaded Cables - Top View
Step 5. Slide the two frame slides into the dedicated rails in the metal frame. See Figure 36.
In the next you will be attaching the rails to the chassis, before doing that, make sure
the cables are laid properly within them. Avoid using excessive pressure, as it can
damage the cables.
To Next Page
Loading...
