Mellanox Technologies SN2100 - Figure 36: Sliding the Frame Sliders into the Rails; Figure 37: Installing the Cage Nuts

Installation Rev 1.6
Mellanox Technologies
35
Figure 36: Sliding the Frame Sliders into the Rails
Step 6. Place the frame in the cabinet, and install ten cage nuts in the desired 1U slots of the rack: three
cage nuts in the front part of each cabinet post, and two cage nuts in the rear part of each cabi
-
net post.
Figure 37: Installing the Cage Nuts
Step 7. Attach the frame to the rack by using ten spacer cage nut to adapt the square openings in the
vertical support, and screwing ten M6 pan head screws - four in the front part of the rack, and 6
in its rear part. The recommended torque is 6.55-7.35 Nm. See
Figure 37.
R
F