36
TV BASIC OPERATION
Adjust the volume level by pressing the VOLUME Up 1 or
Down 2 button.
3
4
Change the Antenna option to select between TV or CATV.
Select AIR if using VHF/UHF antenna, and select CATV if
using Cable TV (see page 25, steps 1 and 2).
2
Press the POWER button 1 on the remote, or front of the
unit, to turn on the unit; the POWER indicator will light
yellow. Press the TV/AV button 2 repeatedly to select the
TV mode. If the unit is in DVD mode, press the TV/DVD
button 3 first, then press the TV/AV button repeatedly to
select TV mode.
1
OPTIONS
TV:
If using a
VHF/UHF
antenna.
CATV: If using Cable
TV.
NOTES:
• When ANTENNA option is set to AIR, only channels
up to 69 can be chosen. When set to CABLE,
channels up to 125 can be chosen.
FAQs:
Why do I only receive 69 channels, when my cable goes much higher?
The TV/CATV option must be set to CATV when using cable, see step 2 above.
Why are some channels scrambled?
You must subscribe to these channels through your cable company.
For proper operation, before selecting channels, they must
be set into the unit’s Program memory, see page 25.
Press and release the CHANNEL Up
1 or Down 2 button.
The unit automatically stops at the next channel set into
memory.
Direct Program Selection/Number buttons (0-9) 3
Use these buttons to select a channel. The channel number
will appear at the top right corner of the screen.
• For Channels 1 through 9, press 1-9
3 as desired.
• For Channels 10 through 99, press -/-- button 4 once,
then enter the 2 digit channel number in order
.
• For Channels 100 through 125, press -/-- button 4 twice,
then enter the 2 digit channel number in order.
To Next Page
Loading...
Need help?
General
