45
Preparation / Status display of disc
NOTE:
If the TV/VCR/DVD does not operate
properly: Static electricity, etc., may af-
fect the player's operation. Disconnect the
AC power cord once, then connect it
again.
DVD
Audio CD
To make status display disappear, press DISPLAY/CALL again.
Status display of disc
Press DISPLAY/CALL second times. The status display of the
disc will appear on the screen.
• When you play a CD disc, the status display will appear
and remain on the screen.
Preparation
Before DVD/CD operation, please make preparations as follows.
1
2
3
Insert the AC cord plug into a standard 120V 60Hz polarized
AC outlet.
• If the AC cord plug is plugged in for the first time, wait for
about 5 seconds before pressing POWER.
NOTE: When connecting to other equipment, unplug the TV/
VCR/DVD from the AC outlet.
Press POWER on the TV/VCR/DVD or on the remote con-
trol to turn on the TV/VCR/DVD. The Power indicator will light.
• Every time you press POWER, the TV/DVD starts from TV
mode.
• When using an amplifier, switch on the amplifier.
Press DVD to select DVD
mode.
The DVD startup screen will ap-
pear on the screen.
No Disc
The following pages describe the
setup/operation in DVD mode.
Disc operation
00:34:56 01:12:33
1/9
Title 1/99
1/8
1/32
Chapter 1/999
EngDolby Digital
Eng
Title number
Chapter number
Title elapsed playing time
Title total time
Camera angle
Type of audio
Subtitle language
Audio language
34:56 71:33
Track 11/99
Disc operation
Track number
Track total time
Track elapsed playing time
5Q00401AE(43-48) 26/5/04, 10:4745
To Next Page
Loading...
Need help?
General
