The parameters you can set in CONFIGURATION MODE are here above
explained in the same order they appear clicking MENU/<< button.
Night Vision
Clear test
data
Beacon
obscuring
time
The MyChron 3 display can be set to backlight display so that it
is visible during night racing.
To set the Night Vision ON or OFF, press button MEM/OK until
the required selection appears. To return to main display mode
press button VIEW.
When the Night Vision option is activated a light globe will be
displayed in the display’s top right corner.
To activate Night Vision mode during a test, it is enough to
press button MENU/<<.
The “Clear test data” option clears the data stored in the
system’s memory.
To run this function, after having entered the CONFIGURATION
MODE, push MENU/<< till when you don’t see
CLEAR TEST DATA
Then press button MEM twice to erase data or press VIEW to
quit.
This function sets the beacon obscuring time. This parameter is
important to avoid the risk of false lap time in case of more than
one beacon transmitter on the track side ( if Infra Red receiver
is employed ) or in case of multiple magnetic strips on the track
24
To Next Page
Loading...
Need help?
General