( if magnetic receiver is employed and you don’t want to see
split times).
For instance, if your Lap time is about 1 minute, set this
parameter at 50 seconds.
AIM suggests always installing only one transmitter at the
trackside.
The Beacon obscuring time can be set between 3 and 59
seconds.
To run this function, after having entered the CONFIGURATION
MODE, push MENU/<< till you don’t see
OBSCURING TIME
Then push MEM to enter EDIT MODE: use button MENU/<< to
change numbers and button >> to change digit. The blinking
number identifies the digit that can be edited.
Press button MEM to save the changes or button VIEW to
discard the changes.
Split’s
number
This function sets how many “split beacons” you have on the
track. It’s possible, in some particular application, to have more
than one transmitter on the track: additional transmitters than
the first one installed on the straight give “ split time ”. If there is
more then one transmitter, you can choose to capture the
segment times by setting the “Number of Splits” or ignore the
segment times by using the “Obscuring Time Option” (see
previous page).
25
To Next Page
Loading...
Need help?
General