ENGLISH
90
Water connection to cold water
Connect the inlet hose to a threaded 3/4 inch connection
and check that it is properly fitted. If the water pipes are
now, or have not been used for a long time, allow the water
to run for a while until it is clear and free from impurities.
Otherwise there is a risk of blocking the water inlet and
damaging the machine.
WARNING: Turn off the water supply after use.
CONNECTION OF OUTLET HOSE
Insert the outlet hose in the drain pipe (min. diameter 4 cm), or allow the water to run out into the kitchen
sink. Make sure the hose is not bent or clenched. Use the plastic support supplied with the machine. The
free end of the hose must hang lower than 75 cm and must not be submerged in the water to prevent
backflow.
NOTE: The plastic support for the hose must be properly fastened to the wall to prevent the outlet hose
from moving and to prevent the water from running out somewhere else instead of into the drain.
To Next Page
