Eng,ne cover open11d
1 Stop lever on 1niec1,on puinµ (example)
114
6.7 Jump starting
If the battery is flat the engine can be started with jumper cables (minimum lead
cross section is 25 mm2) and the ( 12 V) battery of another vehicle.
Proceed as follows:
- Turn key in steering lock to position
,.O".
- Run engine of jumper vehicle at high idle.
- First connect jumper cables to the positive battery terminals and then to the
negative terminals.
- Start engine as normal. Refer to section 3.2.
- After the engine has started, first remove jumper cable from the negative battery
terminals and then from the positive terminals.
Notes:
- Only use slave cables with insulated terminal clamps.
- A flat battery can freeze at approx. -10 °C. In all cases it must be thawed out
before jumper leads are used .
- Never lean over batteries while jump starting, you might get burnt.
- 210 - 410
Vehicles with catalyst:
Only jump start when the engine is cold and the catayst is cooled down.
Should the engine fail to start within a few seconds, discontinue starting attempt
Avoid repeated starting attempts. Consult workshop .
6.8 Shutting off the engine when the vacuum system is faulty
Open engine cover and push down stop lever on injection pump until the engine
stops.
To Next Page
Loading...
