EasyManua.ls Logo

Mercury 150 - Installation Specifications; Lifting the Outboard

Mercury 150
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OUTBOARD INSTALLATION
55
Installation Specifications
a
b
a
18552
a - Minimum transom opening b - Engine center line for dual engine -
66.0 cm (26 in.)
Minimum Transom Opening
Single engine 84.8 cm (33-3/8 in.)
Dual engine 151.8 cm (59-3/4 in.)
Lifting the Outboard
!
WARNING
Avoid possible serious injury or death. Before lifting the outboard, verify that the lifting ring is threaded
into the flywheel for a minimum of five turns and that the hoist has the correct lifting capacity for the
engine weight.
To lift the outboard:
1. Remove the cowl from the outboard.
2. Thread the lifting eye into the flywheel hub for a minimum of five turns.
24215
3. Connect a hoist to the lifting eye.
4. Lift the outboard and place it on the boat transom.

Table of Contents

Other manuals for Mercury 150

Related product manuals