Mercury 150 - Front Clamp Reassembly

OUTBOARD INSTALLATION
71
IMPORTANT: The idle stop screw must be touching the stop.
a
b
7740
a - Idle stop screw b - Idle stop
5. Lock the barrel holder in place with the cable latch.
Front Clamp Reassembly
IMPORTANT: Sufficient slack must exist in engine wiring harness, battery cables, fuel hose, and oil
hoses routed between clamp and engine attachment point, to relieve stress and prevent hoses from
being kinked or pinched.
1. Place the neoprene wrap over the wiring, hoses, and control cables.
3766