Mercury 150 User Manual

OUTBOARD INSTALLATION
67
On counter rotation outboards, the shift linkage moves in the opposite direction compared to a standard
rotation outboards.
a
b
24498
Standard rotation outboards
a - Forward gear b - Reverse gear
a
b
24497
Counter rotation outboards
a - Forward gear b - Reverse gear
Installing the Shift Cable
IMPORTANT: The shift cable is the first cable to move when the remote control handle is moved out of
neutral, so install/connect it to the engine first.
LOCATING THE CENTER POINT OF THE SHIFT CABLE
IMPORTANT: Locate the center point of the slack or lost motion that exists in the shift cable for proper
adjustment of the shift cable.
1. Mark the forward position as follows:
a. Move the remote control handle from neutral into forward and advance the handle to the full
speed position. Ensure that the throttle control lever is touching the throttle control lever stop
screw.
b. Slowly return the handle back to the neutral detent position.
c. Place a mark on the shift cable against the cable end guide.
4355
a
a - Forward position mark

Mercury 150 Specifications

General

Fuel Induction System	Electronic Fuel Injection (EFI)
Horsepower	150 hp
Steering	Hydraulic
Shaft Length	20" / 25"
Starting	Electric
Weight	455 lbs (20"), 462 lbs (25")