GEAR HOUSING
Page 6-28 90-857138R1 MAY 2000
3. Mount a suitable screwdriver or drift punch in a vise. Tool must 1) fit into end of propeller
shaft and 2) compress spring as shown.
4. Compress spring beyond cross pin hole and insert punch thru cross pin holes to retain
spring as shown.
5. Install cross pin opposite to punch driving punch out of clutch as cross pin is installed.
Cross pin should be centered into clutch, as shown.
a
b
a
b
c
d
d
d
b
b
56448
56449
a - Suitable Screwdriver Blade or Punch
b - Punch
c - Spring
d - Cross Pin
6. Apply a small amount of 2-4-C w/Teflon Marine Lubricant to hold guide and cam follower
in place. Install guide and cam follower into end of propeller shaft.
7. Install reverse gear and washer onto propeller shaft as shown.
a
b
c
d
56401
56400
95
95
2-4-C With Teflon (92-825407A12)
a - Guide
b - Cam Follower
c - Reverse Gear
d - Washer
To Next Page
Loading...
