OPERATION
101
9. Wind the starter rope around the flywheel a few turns
clockwise. Give it a sharp tug to start the engine. Use a socket
wrench to get a firm grip on the end of the rope.
10.Remote control models: Ensure the key switch is in the "ON"
position.
NOTE: Confirm that the shift lever is in the Neutral (N) position.
WARM-UP
Before driving the boat, let the engine run at low speed for
approximately three minutes to let it warm‑up. If the engine is not
warmed up beforehand, the engine life will shorten greatly. During
the warm‑up operation, confirm that cooling water is discharged
from the water pump indicator hole and idle port.
IMPORTANT: If cooling water is not discharged and engine
operation is continued, the engine may overheat and damage may
occur.
a - Cooling water
discharge port
b - Idle port
Engine speed:
Proper idle speed after warm‑up operation
To Next Page
Loading...
Need help?
General
