MAINTENANCE
114
2. Clean the fuel filter on the engine after removing the fuel filter
cases.
a - Oil filter
b - Fuel filter
3. Oil filter and oil tank: Check the oil tank and/or filter for
entrapped water and dust.
a. Disconnect all hoses between the oil tank and oil pump.
b. Clean out all the foreign debris.
c. Refit the hoses to the oil tank and pumps, and fill up with
new engine oil.
d. For air purging, refer to Fuel & Oil - Oil pump vent.
Fuse Replacement ‑ Electric Start Remote Control
Models
IMPORTANT: Always carry spare SFE 20 amp fuses.
The electric starting circuit is protected from overload by an SFE
20 amp fuse. If the fuse is blown, the electric starter motor will not
operate. Try to locate and correct the cause of the overload. If the
cause is not found, the fuse may blow again. Replace fuse with a
fuse of the same rating.
Corrosion Control Anode
Your outboard has a corrosion control anode installed on the
gearcase and in the cylinder. An anode helps protect the outboard
against galvanic corrosion by sacrificing its metal to be slowly
corroded instead of the outboard metals.
To Next Page
Loading...
Need help?
General
