3.
Open the hood. Refer to Hood Opening.
a - Hood
b - Oil fill cap
c - Dipstick
4. Remove the dipstick.
5. Install the fluid drain hose from the fluid transfer pump assembly onto the
oil dipstick tube. The lock button on the fluid drain hose will snap into
place.
a - Fluid drain hose
b - Lock button
NOTE: A powered Mercury fluid transfer pump is recommended, as it is
equipped with an appropriate fluid drain hose. If an alternative transfer pump is
used, obtain a Mercury oil drain hose to adapt to the pump.
MAINTENANCE
eng 95
To Next Page
Loading...
