MAINTENANCE
107
INSPECTING BELTS
NOTE: Minor, transverse cracks (across the belt width) may be
acceptable. Longitudinal cracks (in the direction of belt length) that
join transverse cracks are not acceptable.
a - Fraying
b - Transverse cracks
c - Longitudinal cracks
The belt will have to be replaced for the following conditions:
• Excessive wear
• Cracks as explained previously
• Fraying
• Glazed surfaces
Fuel Filters
!
WARNING
Avoid serious injury or death from a gasoline fire or explosion.
When changing fuel system components be sure that the ignition
key is "OFF", that the lanyard stop switch is positioned so that
the engine cannot start, and that there are no sources of high
heat, spark, open flame, or lit smoking materials in use in the
area. Wipe up any spilled fuel immediately.
To Next Page
Loading...
