OPERATION
43
2. Control shifting by moving the shorter control lever(s). This
control shifts the unit into gear with full lever movement. Move
the lever forward to engage the forward gear. Move lever
backward to engage reverse gear. Place the lever in the
center position to shift to neutral. Shifting should occur only
with the engine at idle speed. Always move to the desired gear
position with a quick, firm motion. The control handle should
be adjusted by your dealer to engage forward, reverse, and
neutral when the lever is at the appropriate detent.
a
b
c
4090
a - Throttle control lever
b - Power trim switch
c - Shift control lever
3. See Power Trim section for detailed power trim operating
procedures.
Remote Controls
All controls feature an integral safety switch that allows starting the
engine in neutral only. If the boat is equipped with a remote control
other than that shown, consult your dealer for a description and/or
demonstration of the control.
To Next Page
Loading...
