OPERATION
55
3. If the engine is cold, make sure the engine is idling smoothly
before operating the boat.
4. After the engine has warmed up, check the water temperature
gauge to ensure that the engine temperature is not abnormally
high. If it is, stop the engine immediately and determine cause.
5. Ensure that the charging system is functioning correctly.
6. Observe the power package for fuel, oil, water, and exhaust
leaks.
STARTING PROCEDURE IF ENGINE IS SHUT OFF OR
STOPS WITH DRIVE UNIT IN GEAR
1. Pull/push remote control handle to neutral‑lock position (it will
be necessary to exert force to move handle).
2. Turn the key to the "START" position momentarily, to release
the clutch from gear.
3. Resume the normal starting procedure.
SHIFTING
1. To shift the drive unit into gear, move the control/shift lever
with a firm, quick motion forward to shift to forward gear, or
backward to shift to reverse.
2. After shifting the drive unit, advance the throttle to the desired
setting.
STOPPING
1. To shift the drive unit out of gear, throttle the engine back to
idle speed, then move the control/shift lever to neutral. If the
engine has been operating at high speed for a long period of
time, allow the engine to cool by running at idle speed for three
to five minutes.
2. Turn key switch to "OFF."
Operation Chart
1.
Before Starting
Open the engine hatch.
Turn battery switch "ON," if equipped.
Operate bilge blowers, if equipped.
Open fuel shut off valve.
To Next Page
Loading...
