COLD WEATHER OR EXTENDED STORAGE
119
Draining Instructions
!
CAUTION
To prevent damage from freezing temperatures, remove and
plug the seawater inlet hose. This prevents a siphoning action
that may occur, allowing seawater to flow into the drain holes or
hoses.
Completely drain the cooling system for winter storage, or
immediately after cold weather use, if the possibility of freezing
temperatures exist. Failure to comply may result in trapped water
causing freezing and/or corrosion damage to the engine.
IMPORTANT: The boat must be as level as possible to ensure
complete draining of cooling system.
1. Remove the following drain plugs:
NOTE: Removing the drain plugs from the following locations will
ensure that the charge cooler is drained.
• End of exhaust manifold balance rails (plastic wing‑nut
plugs, port and starboard)
• Fuel cooler (plastic wing‑nut plug, Starboard side of the
engine)
To Next Page
Loading...
