EasyManua.ls Logo

Mercury Racing Sterndrive 600SCi - Bravo Drive Maintenance Charts

Mercury Racing Sterndrive 600SCi
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAINTENANCE
67
Interval Task
Every 100 hours of operation or once a
year, whichever occurs first.
Supercharger ‑ Change oil.
Power package exterior surfaces ‑
Clean and paint.
Check engine cylinder compression.
Oil coolers for the engine and power
steering ‑ Clean seawater section.
Replace positive crankcase
ventilation (PCV) valve.
Flame arrestor and crankcase
ventilation hose ‑ Inspect, clean or
replace.
Engine alignment ‑ Check.
Exhaust ‑ Check for signs of water
leakage.
Exhaust system internal and external
shutters ‑ Inspect.
Engine output shaft, bearing, and pilot
bushing ‑ Inspect and lubricate.
Rear bearing support block ‑ Check
alignment.
MerCathode system ‑ Test output.
Every 100 hours of operation or
recommissioning after storage.
Fuel filters ‑ Replace.
Every 100 hours of operation or once a
season and whenever insufficient
seawater flow is suspected (if the
operating temperature exceeds
normal).
Seawater pick‑up pump ‑
Disassemble and inspect.
Every 200 hours of operation.
Ignition system ‑ Clean and inspect
condition. Adjust or replace spark
plugs as needed.
Every 5 years.
Flush the closed cooling system and
refresh coolant.
Bravo Drive Maintenance Charts
NOTE: Only perform maintenance which applies to your particular
power package.

Table of Contents

Related product manuals