MAINTENANCE
113
PAINTING THE BOAT HULL OR BOAT TRANSOM
If anti‑fouling protection is required for the boat hull or boat
transom, copper or tin base paints can be used unless otherwise
prohibited by law. If using copper or tin based anti‑fouling paints,
avoid any electrical interconnection between the Mercury Marine
Product, anodic blocks, and the paint by allowing a minimum of 40
mm (1.5 in.) unpainted area on the transom of the boat around
these items.
a - Anti‑fouling paint
b - Unpainted area
IMPORTANT: Corrosion damage that results from the improper
application of anti‑fouling paint will not be covered by the limited
warranty.
To Next Page
Loading...
