MAINTENANCE
72
1. Stop the engine and turn the drive unit the straight ahead
position.
2. Remove the fill cap/dipstick and observe the level. The oil level
must be between the lower and upper marks.
3. Add power steering fluid if required to bring the oil level up to
the full mark on the cap/dipstick.
a - Power steering reservoir fill/dipstick cap
b - Add fluid mark
c - Full fluid mark
Tube Ref No. Description Where Used Part No.
114
Power Trim and
Steering Fluid
Power steering pump
92-858074K0
1
4. Re‑install the cap/dipstick.
SEAWATER/FUEL PUMP OIL
IMPORTANT: Oil must be changed at specified intervals. Refer to
the Maintenance Chart for specific requirements. Use only High
Performance Gear Lube in the pump.
1. Remove the fill screw and check the oil level.
To Next Page
Loading...
