EasyManua.ls Logo

Merrychef eikon e2 - Oven Installation Guidelines; Oven Placement and Location Requirements

Merrychef eikon e2
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
Installation and User Manual  Original, GBR
Part Number 32Z3838
Issue 7
PRODUCT DETAILS
INSTALLATION
The oven should not be operated without
the AIR FILTER tted correctly in place.
Check for obvious signs of transit damage.
If necessary, inform the freight company IMMEDIATELY.
Remove packing material and protective lm from the
oven and safely discard.
Included inside your oven:
Model e2 Series:
Cooking Plate (x1).
OVEN LOCATION AND POSITIONING
Choose a site away from major heat sources.
DO NOT position so that hot air is drawn in from fryers,
grills, griddles, etc.
A heat barrier to the height of the oven must be installed if
sited next to a burner, stove or range.
Place the oven on a permanent nonslip/nonammable at
surface that is LEVEL, STABLE and STRONG enough for the
oven and contents.
Allow per oven, a minimum clearance (A) of 2 inches
(50mm) around the oven for hot air to escape.
Allow sucient clearance (B), in front of the oven for the
door to open fully.
The air intake is located at the rear top of the oven (1)
and it is important that the airow is as cool as possible
and not preheated by other appliances such as burners,
stoves, ranges, fryers, grills and griddles as this will
deteriorate the life and performance of the oven.
Do not ax labels/stickers to oven other than those
applied or approved by the manufacturer.
The appliance is to be supplied through a residual current
device (RCD) having a rated residual operating current of
30mA.
This appliance is intended for counter top applications,
it is not recommended to be placed on counter tops
greater than 1100mm from the ground or below a
height likely to cause repetitive injury or strain due to
the ergonomics of its installation.
When installing ensure that it is safe to both remove
and place products into the oven without causing
injury.
HANDLING & STORAGE
When moving an oven always observe and follow national
and local requirements for lifting and moving heavy
objects. Do not use the oven door handle to lift oven.
When not in use, electrically disconnect the oven and store
safely in a dry cool place, do not stack ovens.
TWIN OVEN CONFIGURATIONS
Position adjacent ovens allowing the minimum clearances
shown. Note that if a parent oven is used, this is connected
to the mains supply and on the rear panel a mains socket
for the dependent oven is provided.
NOTICE: Do not plug any other appliance than the
dependent oven into this socket.
NOTICE
DO NOT PLUG ANY OTHER APPLIANCE THAN
THE DEPENDENT OVEN INTO THIS SOCKET.

Other manuals for Merrychef eikon e2

Related product manuals