METEK Micro Rain Radar MRR-2 Page 27
2012-03-01 Valid for MRR Service Version 6.0.0.4 / Firmware 6.00
Recording Options
Raw Spectra
spectra
written in addition to other selected data to a separate log-file. The path name
of these files is defined by the parameters RawSpectraFile and
RawSpectraPath.
Conditional recording
data are only recorded if the evaluation
software detects precipitation during the measuring (averaging) interval. This
condition can be activated separately for averaged/processed data and raw
spectra respectively.
Measuring Height(s)
A subset of measuring heights can be selected for recording. This subset is
used for both kinds of data output, processed and averaged data. The
selection of measuring heights for output is done with two lists containing the
selected and unselected height steps. To move items (sets of height steps)
between the lists they must be marked in the source list. The movement will be
performed when the arrow button pointing to the other target list is pressed.
(The height resolution (step-width) can be adjusted with the device parameters
menu (see chapter 6.3.4 on page 28)).
Time Zone
The time zone can be selected which is used for the time stamps of the
recorded data.
All changes in the Output Parameters Menu become effective by clicking the
Ok button. Then the corresponding commands are transmitted to the RCPD
all changes.
To Next Page
Loading...