Metek MRR-2 - Parameter Storage

Page 30 Micro Rain Radar MRR-2 METEK
2012-02-29 Valid for MRR Service Version 6.0.0.3 / Firmware 6.00
6.3.5 Parameter Storage
Figure 23: Parameter Storage
Parameter Sets
The parameter memory of the MRR-2 is used for convenient saving and
loading of complete parameter settings.
A parameter set consists of
- the device parameters (except calibration constant) and
- the selected output parameters
Saving a parameter set:
 Type a name in the field right of the Save-button or select a name of
the Parameter Sets list.
 Click the Save-button.
Loading a parameter set:
 Type a name of the Parameter Sets list in the field right of the Save-
button or select a name of the Parameter Sets list.
 Click the Load-button.