Metek MRR-2 - Page 31

METEK Micro Rain Radar MRR-2 Page 31
2012-03-01 Valid for MRR Service Version 6.0.0.4 / Firmware 6.00
Deleting a parameter set:
 Type a name of the Parameter Sets list in the field right of the Save-
button or select a name of the Parameter Sets list.
 Click the Delete-button.
Program List
Previously defined parameter sets can be added to a program list. All sets
which are included in this list, will be processed successively. This means
every time the averaging interval has finished, the next entry will be loaded
from the list. After reaching the end of this list, the program starts over with the
first entry.
Creating a Program List
 Select a parameter set in the Parameter Sets list
 Click the Append button. The parameter set is inserted in the empty
Program List or added to the end of the non-empty Program List.
As soon as the Program List is not empty, it becomes active.
Removing entries from the Program List
 Select the entry from the Program List
 Click the Remove-button
Note:
1. Parameter sets which appear in the Program List can neither be
changed nor deleted.
2. The same parameter set name may appear at several places in the
Parameter List.