Metek MRR-2 - Page 33

METEK Micro Rain Radar MRR-2 Page 33
2012-03-01 Valid for MRR Service Version 6.0.0.4 / Firmware 6.00
Sub-Panel: “Data Recording”
 Disk capacity exhausted in
The remaining time for data recording is shown. The calculation is based
on the average sizes of the last received measuring protocol and the
actual free disk space (Initially ??? appears until the first data set is
stored).
 Time since last recording
The time elapsed, since the last averaged and processed data sets were
written to disk, is shown (Initially ??? appears until the first data set is
stored).
 Round time stamps to minutes
Time stamps are rounded to integer values. This can be useful under the
following condition: If the "Adjust interval length to real time clock" (see
chapter 6.3.2 Control Commands Menu) was selected, the time stamps
should be integer multiples of 10 seconds, minutes or ten minutes.
Nevertheless small deviations from these integers may occur due to
variable processing time. If this is disturbing for subsequent data analysis
programs, the recorded time stamps can be rounded. The selection yes or
no is activated by pressing the ok button.
Sub-Panel “Errors”
This panel shows a list of errors which occurred during the measuring
operation. Errors which occurred before the control program was started can
be retrieved from the Windows® event log.
About Button
Version information about the control program appear if 
button.