EasyManua.ls Logo

Metek MRR-2 - Page 36

Metek MRR-2
53 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 36 Micro Rain Radar MRR-2 METEK
2012-02-29 Valid for MRR Service Version 6.0.0.3 / Firmware 6.00
Example (Each entry of the header line is shown in a separate line of the table) :
MRR110124040200UTC
The header line dates from January 24th, 2011, 4:02
AM, UTC.
AVE␣␣␣␣60
Averaging time is 60 seconds.
STP␣␣␣␣35
Height resolution is 35 meters.
ASL␣␣␣147
The radar is sited 147 meters above sea level.
SMP125e3
Sampling rate is 125,000 Hz.
SVS6.0.0.1
Version number of the MRR Service is 6.0.0.1
DVS6.00
Version number of the MRR firmware is 6.00.
DSN0502082121
Serial number of the MRR is 050208121.
CC2066000
Calibration constant is 2066000.
MDQ100
Percentage of valid spectra is 100
TYPAVE
data are averaged data
H - Height
Argument of the following data profiles corresponding to the settings described
in chapter 6.3.3, page 26, and chapter 6.3.4, page 28. The units are meters
above the radar system.
TF - Transfer Function
To each height step a value of the Transfer Function is assigned by which raw
spectra are divided.
Fnn with nn from 0 to 63 - FFT Spectra
Each line represents a profile of spectral reflectivity corresponding to the
spectral bin nn. As Fnn is corrected for the receiver noise floor negative values
can occur, if the signal to noise ratio is low. These entries cannot be presented
in the logarithmic domain and are replaced by space characters.
Dnn with nn from min(h) to max(h) - Drop Sizes
The drop size is described by the diameter of an equivolumic sphere. The
spectral bins of drop numbers are of variable width in the size domain (in
contrast with spectral bins in the frequency- and velocity-domain). In addition,
the widths of the size bins are slightly height dependent. Therefore the
assignment of frequency-bin-index nn to diameter D is listed explicitly for each
bin and height. The center of each size class is displayed.