METREL MI 3125 Short Instructions

MI 3125 / MI 3125E EurotestCOMBO Start-up guide
10
1.8 Contact Metrel UK
Metrel UK
Unit 1, Hopton House, Ripley Drive
Normanton Industrial Estate
Normanton,
West Yorkshire
WF6 1QT
Tel.:+44/ (0) 1924 24 50 00
Fax: +44/ (0) 1924 24 50 07
E-mail: info@metrel.co.uk
Web: www.metrel.co.uk
Update your meter
Metrel offers a service of updating your software of firmware to the latest developments.
Register on www.metrel.co.uk to receive updates of PC SW and firmware of the meters.
Calibrate your Meter
Metrel offers a calibration service of all Metrel equipment. Contact Metrel UK on 01924
245000 and ask for the calibrations department.
Repair
Metrel offers a repair service of all Metrel equipment. Contact Metrel UK on 01924
245000 and ask for the repairs department.
Ask a technical question
Metrel offers a Technical Advice Line every Mon-Thu from 8:00 a.m. till 5.00 p.m. and
Fridays from 8:00 a.m. till 4 p.m.
Get training on Metrel meters
Metrel offers training on site or at the office subject to a charge.

METREL MI 3125 Specifications

General

Type	Multifunction Installation Tester
Insulation Resistance	Yes
Continuity Test	Yes
Loop Impedance	Yes
RCD Testing	Yes
Voltage Measurement	Yes
Frequency Measurement	Yes
Display	LCD
Power Supply	6 x 1.5 V AA batteries
Loop Resistance Resolution	0.01 Ω
Frequency	45 - 65 Hz
Line Voltage Resolution	1 V
Insulation Resistance Test Voltage	50 V, 100 V, 250 V, 500 V, 1000 V
Insulation Resistance Resolution	0.01 MΩ
Continuity Resistance Resolution	0.01 Ω
Test Current	200 mA
DC Voltage	Up to 600 V
Loop Resistance	0.0 Ω - 1999 Ω
Line Voltage	Up to 550 V
Line Voltage Accuracy	±2% ±2 digits
Rated Residual Current	10 mA, 30 mA, 100 mA, 300 mA, 500 mA
Insulation Resistance Range	0.01 MΩ to 1 TΩ
Continuity Resistance	0.0 Ω - 1999 Ω
Dimensions	220 x 103 x 55 mm
Operating Temperature	-10°C to 50°C
Storage Temperature	-20°C to +60°C
Safety Standards	EN 61557
Loop Resistance Accuracy	±(5% + 3 digits)