Need help?Do you have a question about the METREL MI 3295 and is the answer not in the manual?
General| Category | Measuring Instruments |
|---|---|
| Model | MI 3295 |
| Manufacturer | METREL |
| Continuity | Yes |
| Continuity resolution | 0.01 Ω |
| RCD testing | Yes |
| Earth resistance | Yes |
| Specific earth resistance | Yes |
| Touch voltage | Yes |
| Varistor testing | Yes |
| Illuminance | Yes |
| Harmonics | Yes |
| Power | Yes |
| Power factor | Yes |
| Data logging | Yes |
| PC software | Yes |
| Display | LCD |
| Power Supply | Rechargeable battery |
| Communication Interface | USB, Bluetooth |
| Protection Class | IP54 |
| Operating Temperature | -10 °C to +50 °C |
| Weight | 1.5 kg |
| Resistance Range | 0.01 Ω to 20 kΩ |
| Insulation Resistance Range | 0.01 MΩ - 20 GΩ |
| Storage Temperature | -20°C to +60°C |
| Type | Multifunction Tester |
| Test Voltage | 250 V, 500 V, 1000 V |
| Frequency Range | 16 Hz to 400 Hz |
General safety warnings and precautions for instrument usage and damage prevention.
Interpretation of warning icons and messages shown on the MI 3295M meter.
Explanation of warning messages and protective measures for the MI 3295S station.
Principles of earthing, fault currents, dangerous voltages, and measurement theory.
Introduction to measurement methods including Step voltage and Contact/Touch voltage.
Detailed procedures for performing Step, Contact/Touch voltage, and Potential measurements.
Steps for injecting test current using the MI 3295S prior to voltage measurements.
Recommended procedure for synchronizing Meter and Station before measurements.
How to conduct Step and Contact/Touch voltage measurements with the MI 3295M meter.
Detailed steps and test parameters for performing potential measurements.
Procedure for synchronizing Meter and Station after tests for data correction.
Steps for conducting earth resistance measurements and interpreting the results.
Detailed procedure for measuring specific earth resistance using the Wenner method.
Technical specifications for Step and Contact/Touch voltage measurements.
Technical specifications for current measurements using the MI 3295S station.
Technical specifications for earth resistance measurements.
Technical specifications for specific earth resistance measurements.
Technical specifications for potential measurements using the MI 3295M meter.
To Next Page