METREL MI 3295 User Manual

MI 3295 Step Contact Voltage Measuring System MI 3295S Station operation
21
Date / time was changed in the Station and consequentially
the synchronization between Station and Meter is lost. The
Current logger must be cleared. Before clearing it its content
can be downloaded to the Meter.
In the message field warnings and messages are displayed.
Output power is not set to maximum
Measurement is running; consider displayed warnings.
High electrical noise was detected during measurement. Results may be
impaired.
High resistance of current (c) and/ or voltage (p) probes. Results may be
impaired.
Result(s) can be stored.
6.3 Help screens
Same as in MI 3295M – see chapter 5.4.2 Help screens.
The help screens can be accessed with the HELP key.
6.4 Contrast adjustments
With the LIGHT key contrast can be
adjusted.
Figure 6.4: Contrast adjustment menu
Keys for contrast adjustment:
Cursor LEFT / RIGHT
Sets contrast.
TEST
Accepts new contrast.
ESC
Exits without changes.
6.5 Function selection
For selecting test function the FUNCTION SELECTOR shall be used:
Function selector
Selects test / measurement function.
 <EARTH RE, EARTH > earth resistance
 <CURRENT GEN.> generation of measuring current
 <SETTINGS> settings
Cursor UP / DOWN
Selects sub-function in selected measurement function.
Cursor LEFT / RIGHT
Selects the test parameter to be modified.
Keys in test parameter field:
Cursor UP / DOWN
Changes the selected parameter.

METREL MI 3295 Specifications

General

Brand	METREL
Model	MI 3295
Category	Measuring Instruments
Language	English